Pro Series Network Cards
CPCI 720 Series
The CPCI 720 series is an enhanced version of the popular CPCI 800 adapter, featuring improved architecture and support for wire-speed performance with small packets. The CPCI 720 series is available as a single or dual port HSSI, DS3, or E3 WAN adapter for demanding video and multimedia networking applications.
The CPCI 720 is based on a 32-bit 33 MHz PCI controller that supports bus mastering at a burst rate of 132 MB per second. The main components of the CPCI 720 include the Intel i960HD66 RISC processor, the PCI controller, and two DXI HDLC controllers. The i960 processor manages packet flow between the DXI controller, packet RAM and host RAM. The i960 can act as a PCI bus master with direct access to host RAM, or it can initiate DMA transfers between packet RAM and host buffers via the PCI controller. The VLSI DXI controller module supports both HDLC and transparent modes of operation at speeds of up to 52 Mbps per port. Dual 8/16 KB FIFOs are connected directly to the DXI HDLC controller for both transmit and receive channels to minimize packet transfer latencies.
|
Performance:
- 32-bit 33 MHz PMC interface
- Low-latency PCI bus master
- Supports front or rear panel I/O
- Up to 2 full duplex sync ports
- 52 Mbps full duplex throughput per port
Technical Highlights:
- 6U CompactPCI form factor
- PICMG 2.1 R1.0 hot-swap compliant
- Intel i960HD66 based processor
- 1 MB packet RAM
- 1 MB code RAM
- 0.5 MB flash RAM
- VLSI HDLC controller
- Time stamping option with 1 microsecond resolution
- 16/32 bit CRC
- MTBF greater than or equal to 100,000 hours
Interface Options:
- Single or dual port HSSI
- Single or dual port DS3
- Single or dual port E3
|
|
Interface Specifications:
- HSSI: ANSI/TIA/EIA-613-1993
- DS3: ANSI T1.102, T1.107-1195, T1.404-1994, TR-TSY-000009
- E3: ITU G.742, G.745
- DS3 and E3 cards use G.703-compliant 75 ohm BNC connectors
Environmental Requirements:
- Operating temperature 0 to 55 degrees C (32 to 131 degrees F)
- Relative humidity to 90% (non-condensing)
Power Requirements:
- 2.2 amps @ 5 volts (max)
- 0.2 amps @ 12 volts (max)
- 0.4 amps @ -12 volts (max)
Certification:
|
Model Numbers and Interface Configurations:
- 721-HS - One HSSI interface
- 722-HS - Two HSSI interfaces
- 721-DS - One DS3 CSU/DSU interface
- 722-DS - Two DS3 CSU/DSU interfaces
- 721-E3 - One E3 CSU/DSU interface
- 722-E3 - Two E3 CSU/DSU interfaces
|
|
|
|
| |
|
Save on Certification
|
|
|
|
|
Meet Us at ISPCON
|
|
|
|
|
|
|
Lab Test
|
|
|
Lab Test
of the
Rebel
Router
|
|
|
|
Product Review
|
|
|
Reviews
the
TransPort
Router
|
|
|
|
|
